metal

steel, brass
and stainless.

Cut, welded and finished from raw section.

Screens and partitions, door sets in every configuration, arched and radiused frames and fixed lights. Frames are cut, welded and finished from raw section and detailed into the joinery they meet, with partition systems supplied alongside where a project calls for one.

we make

Four lines, one workshop.

in the metal

Dressed back before anything is finished.

Openings are templated in place and the section is rolled or cut to that template, not to the drawing board. Trial fitting happens at the bench, so the frame that leaves the workshop is the frame that gets installed.

Precision welded flat bar junction in blackened mild steel
metalWelded junction | blackened mild steel
Brushed stainless steel door frame with a mitred corner
metalDoor frame | brushed stainless
Brushed brass balustrade post on a polished concrete floor
metalBalustrade post | brushed brass
Polished stainless steel round bar handrail on a stone wall
metalHandrail | polished stainless

Staircases, balustrades and handrails, fixed to our own setting out rather than a supplied kit.

Stringers, treads, posts and infill in steel, brass and stainless. Posts, brackets and junctions are made for the job they sit in and dressed back before finishing.

finishes

Matched to an agreed sample.

One sample runs through fabrication, install and handover, so the finish signed off at the bench is the finish that arrives on site.

Have a project in mind?

Send the drawings or the idea. One team takes it from drawing review through fabrication to installation.

start a projectrequest a brochure